Reflective strips – small and easy to use

 Do you know the definition of reflective strips?

Reflective strips are reflective materials made according to the principle of spherical retro-reflection formed by high-refractive glass beads. They can reflect light back to its light source, producing excellent reflective effects and warning functions. Sticking the reflective strips on the rear of the battery vehicle will be very eye-catching at night and will light up when the light is on. Electric vehicle accidents are frequent. In addition to drivers not complying with traffic rules, many are caused by driving at night or driving on roads with poor lighting, unclear vision, and untimely response.

Reflective stickers are a must-have small accessory for trucks. Although they look inconspicuous, they are required to be installed on every vehicle, so there are a lot of fakes on the market. The most obvious difference between the authenticity and the fake is to judge by the information logo on the reflective stickers.

Do you know the specifications of car reflective stickers?

The most important indicators of reflective stickers are reflectivity, reflection angle, viscosity and durability. At night, when other car lights hit the genuine and fake reflective stickers, the intensity of the light reflected into the human eye is very obvious, and the inferior reflective stickers look much dimmer.

Body position pasting specifications According to regulations, the body reflective logo at the rear of the body should start with a white unit and end with a white unit, and the intersection of the corners at the rear of the cargo compartment should be a white unit. The side can start with a red unit, but the last unit near the rear of the vehicle should be a white unit. After pasting the reflective logo, it cannot affect the performance of the vehicle lighting and signal devices specified in the standard. And it is not allowed to punch holes or grooves on the reflective stickers to damage the reflective logo.

If the reflective sticker cannot be directly pasted on the body due to reasons such as the model, in this case, the reflective logo should be pasted on a strip lining with a certain rigidity, strength, and aging resistance, and then the lining should be fixed on the body. The rear body reflective logo should reflect the width and height of the rear of the vehicle as much as possible. The horizontally pasted reflective logo reflects the width of the rear of the vehicle, and the vertically pasted edges on both sides reflect the height of the rear of the vehicle. Therefore, the intersection of the rear corners of the cargo compartment should be a white unit, which can more clearly show the outline of the rear of the vehicle. Finally, it should be noted that the pasting of the side body reflective logo is allowed to be interrupted, but the total length of the entire side of the body (excluding the spacing part) must be greater than 50% of the body length.